Target muscles: Back of the thighs (hamstrings), Glutes (gluteus maximus)
Cue: Hips back, not down.
Common mistake: Rounding the back to reach lower. Stop where your back starts to round. The range comes from the hips, not the spine.
Overview
Hamstrings and glutes do most of the work in a cable straight bar RDL, with a low pulley supplying the load. You hold the bar with straight arms, push your hips back and then stand tall again. The cable pulls slightly forward, which helps many people learn to keep their weight back over their heels.
Quick facts
- Level: Beginner
- Equipment: Cable machine on a low pulley, with a straight bar
- Movement pattern: Hip hinge
- Force: Pull
- Type: Compound
Muscles worked
Primary: Back of the thighs (hamstrings), Glutes (gluteus maximus)
Secondary: Lower back (erector spinae), Inner thighs (adductor magnus)
In one study comparing common hamstring exercises, the Romanian deadlift produced some of the highest hamstring activity, alongside the glute-ham raise. That study used a barbell, but the hinge is the same.
How to do the cable straight bar romanian deadlift (rdl)
- Set the pulley at its lowest point and attach a straight bar.
- Hold the bar with an overhand grip, hands just outside your thighs. Step back so the weight lifts off the stack when you stand.
- Stand tall with feet hip-width apart, a soft bend in your knees and your shoulders back.
- Push your hips back and let the bar slide down your thighs as your chest tips forward. Keep your back flat.
- Lower until you feel a strong stretch in your hamstrings, usually somewhere between the knees and mid-shin.
- Drive your hips forward to stand tall, squeezing your glutes at the top.
- When you finish, step forward and let the bar return to the stack under control.
Coaching cues
- Hips back, not down.
- Bar stays close to your legs.
- Stand tall. Don't lean back.
Common mistakes
- Rounding the back to reach lower. Stop where your back starts to round. The range comes from the hips, not the spine.
- Bending the knees into a squat. Keep a soft, fixed knee bend and move the hips back instead.
- Standing too close to the machine. Step back far enough that the weight stays off the stack for the whole set.
- Leaning back at the top. Finish with hips and shoulders stacked over your feet. Squeeze the glutes rather than arching.
Easier or harder options
- Easier: Resistance band Romanian deadlift. Lighter and quick to set up, so it suits learning the hinge.
- Harder: Barbell Romanian deadlift. The classic free-weight version. It lets you load the hinge far more heavily.
Training focus
The cable RDL is mostly used to build muscle size and endurance in the hamstrings and glutes, and to practise the hinge. Stack weights rarely match free-weight loads, so it suits moderate sets more than heavy strength work. The energy it needs comes from more than one system, with the balance changing as load and set length change.
FAQs
Why do the RDL on a cable instead of with a barbell?
The cable is easy to set up, the load changes in small steps and you can stop mid-set without dropping anything. That makes it a good place to practise the hinge. A barbell lets you lift much heavier.
How low should the bar go?
As low as you can while your back stays flat. For most people that's between the knees and mid-shin. Tight hamstrings mean a shorter range, and that's fine.
Where should I feel it?
Mostly in the back of the thighs and the glutes. If your lower back takes over, reduce the weight and shorten the range.
Want this in a full plan? The 12REPS app has the cable straight bar romanian deadlift (rdl) with trainer demos, and you can log every set.
Sources
- McAllister MJ, et al. Muscle activation during various hamstring exercises. J Strength Cond Res. 2014.
- Gastin PB. Energy system interaction and relative contribution during maximal exercise. Sports Med. 2001.
← Back to the exercise library · Book a free consultation with Will