BeginnerBackBands

Target muscles: Lats (latissimus dorsi), Middle back (middle trapezius and rhomboids)

Cue: Chest faces the anchor the whole time.

Common mistake: Rotating the torso to pull further. Keep both hips and shoulders facing the anchor. Your elbow stops where your body would have to turn.

Overview

Pulling a band back with one hand, the loop band single-arm pull works your lats and mid-back while your obliques stop your torso from turning. You face an anchor, take the band in one hand and row it to your ribs. Adjust the difficulty by changing the band or how far you stand from the anchor.

Quick facts

  • Level: Beginner
  • Equipment: Loop band and a secure anchor
  • Movement pattern: Standing one-arm band row
  • Force: Pull
  • Type: Compound

Muscles worked

Primary: Lats (latissimus dorsi), Middle back (middle trapezius and rhomboids)

Secondary: Rear shoulders (posterior deltoids), Biceps and brachialis, Obliques

Muscles worked in the Loop Band Single-Arm PullPrimary: Lats (latissimus dorsi), Upper back (rhomboids, mid traps). Secondary: Rear deltoids, Biceps, Obliques. Front Back Primary Secondary

How to do the loop band single-arm pull

  1. Loop the band around a secure anchor at about chest height.
  2. Face the anchor and hold the band in one hand with your arm straight out in front.
  3. Step back until the band is taut. Stand in a staggered stance with the foot opposite your working arm forward.
  4. Row the band towards your lower ribs, keeping your elbow close to your side.
  5. Draw your shoulder blade back at the end, without turning your chest away from the anchor.
  6. Let the band pull your arm forward slowly until it's straight, allowing the shoulder to reach slightly.
  7. Finish one side, then switch hands and stance.

Coaching cues

  • Chest faces the anchor the whole time.
  • Drive the elbow back past your ribs.

Common mistakes

  • Rotating the torso to pull further. Keep both hips and shoulders facing the anchor. Your elbow stops where your body would have to turn.
  • Shrugging the working shoulder. Keep the shoulder down and away from your ear as you pull.
  • Letting the band yank the arm forward. Control the return so the band never snaps back.
  • Standing too close. Step back far enough that there's tension even at the start.

Easier or harder options

  • Easier: Lighter band or shorter stance. A thinner band, or standing closer to the anchor, reduces the tension at the end of the pull.
  • Harder: Dumbbell single arm row. A dumbbell lets you use more load through the whole range.

Training focus

Commonly used for back muscle endurance, home training and warming up before heavier pulling. It can also build muscle when sets are taken close to fatigue. Band tension is highest at the end of each pull. Energy demand is usually modest, with several systems working together.

FAQs

Can a band work my back hard enough?

Yes, if the band is challenging. Tension peaks at the end of each pull, where the back works hardest. To keep progressing, add resistance over time with a thicker band or by standing further back.

Which foot should go forward?

Most people put the foot opposite the working arm forward. It gives a steady base and helps you resist twisting. A square stance also works if you can stay still.

Want this in a full plan? The 12REPS app has the loop band single-arm pull with trainer demos, and you can log every set.

Sources

← Back to the exercise library · Book a free consultation with Will